Wuxi Guorong Machinery Manufacturing Co., Ltd. specializes in the production of gas generators, LZD electrostatic purification and recovery devices, flue gas dust removal devices, and flue gas desulfurization devices.

       The gas outlet temperature is too high and exceeds the specified range. The gas coming out of the fire hole catches fire. The carbon monoxide content in the gas is low and the gas quality becomes poor. The ash layer increases rapidly, and the amount of residual carbon contained in the ash is unstable, and more of it is discharged with the ash residue. When inserting the drill into the gas stove, the material layer felt sticky. Open the fire detection hole and observe. There is a fire on the surface of the material layer in the furnace, with local fire and burn-through.

       How to avoid the hazards of gas generators

       Before ignition, check the gas generator to see if the various pipelines are smooth, whether the valves are flexible, whether the various parts are complete and in the correct position, fill the coal hopper with coal, and fill all water sealing parts with water. When laying the furnace and igniting, use fully burned 30—100mm slag paving furnace. Pay attention to the steps when transporting gas. Stop adding coal half to one hour before shutting down the furnace, and stir out the ash to burn out the fuel. Check the gasification temperature at any time, and each working team must clean the water seal every day.