gas generatorThe preparation before ignition cannot be ignored. First, fill up the coal material, pay attention to filling up the water, frequently used fire tools, including matches, etc., and prepare refractory cement and refractory sand (used to seal the furnace). During operation, the command must be unified and carried out step by step according to the ignition operating procedures of the gas generator. Otherwise, it will cause irreparable losses to the enterprise. During the entire debugging process of the gas generator, the operator must record and observe the temperature of the gas generator and the degree of gasification at all times to ensure the degree of gasification. It is necessary to clean up the debris and other dirt on the facade in time. 

       When igniting the gas generator, be sure to turn off the fan and keep yourself as far away from the stove as possible. Otherwise, we may be hurt by the gas thrown out. If you encounter an emergency power outage, remember to open the release valve immediately to maintain positive pressure in the gas generator. Turn off the water tank leading to the heating in time, drain the water, etc. When operating a gas generator, everyone must always be cautious and careful. This can reduce the occurrence of unnecessary accidents.